Analysis of Bad Cutting Result in Corrugated Carton Board
Part 1: The short life time of Razor Slitter Knives;
a. The poor quality of Carbide raw materials; Its grade is lower. We advise to use YG12X or YG13 to guarantee the quality.
b. Do not choose the suitable grinding wheels; The grinding wheel is with coarse grit size. This will cause the Razor Slitter Knife sharp in very short time but consume the blade very fast.
Part 2: The Corrugated Board is with burrs or unclean-cuts after cutting;
a. Check the edge of Razor Slitter Knife, guarantee it sharp enough;
b. The cardboard is too wet.
Part 3: Breakage of Blades;
a. Sicne the deformed flange plate, Screwing untightly cause the Razor Knife assembly in a unproper way;
b. Unstable swing grinding wheels, the Razor Slitter Knife is not set exactly in the middle of Angles fromed by 2 Grinding Wheels; Check the bearing of Grinding Stone and Set Location;
C. The Knife cut on hard onstacle.
Part 4: It appears chips on the cutting edge of Razor Slitter Knife after grinding;
a. The grit size of grinding wheels is too coarse;
b. The Razor Slitter Knife cut on the grinding stones
C. The Knife cut on hard onstacle.
Part 5: After cutting, the edge of cardboard is not straight;
a. The Razor Knife is with lower hardness;
b. The Blade is too thin.